Create a LAGG interface in Freenas Corral
Ensure the interfaces are not configured.
Remove any DHCP, configured addresses.
Select Network and Create
Check the Enabled box.
Enter a description, the IPv4 address and subnet mask or IPv6 address and prefix length for the new LAGG
DHCP can be enabled and used for this LAGG only if it is disabled for all other Ethernet interfaces in the system.
Set an MTU (1500 is normal).
Choose the two network interfaces to be used in this LAGG.
Select a Protocol
Enter Aliases for the new LAGG interface if desired.
Open a shell
sudo nano /etc/apt/sources.list
Add to the Bottom of the sources list
deb http://www.ubnt.com/downloads/unifi/debian stable ubiquiti
Add the GPG Keys for the repository
sudo apt-key adv –keyserver keyserver.ubuntu.com –recv C0A52C50
sudo apt-get update
Install the unifi package.
sudo apt-get install unifi
Open Web Browser to https://ip_or_hostname:8443/manage
Troubleshooting HDMI out issues on your Raspberry Pi
Open up the config.txt file
sudo nano /boot/config.txt
Ensure that HDMI boost is set to 4. You can change this lower or higher till it works
If still no luck re-open the config.txt file and override the hotplug setting from 0 to 1.
Check that the Raspberry Pi has at least 5V of voltage. You can take this measurement from TP1 to TP2
Try a different cable
If you are still not having luck try to delete the config.txt file and use a backup.
Enter the following command line code to generate RSA keys in ubuntu
chmod 700 ~/.ssh
ssh-keygen -t rsa